Raspberry Pi just announced the Camera Module 3. I built a camera based on @Kevin McAleer’s PIKON design.
Check out the Camera Module 3: https://www.raspberrypi.com/products/camera-module-3/
Mentioned in this video:
– Kevin McAleer’s PIKON: https://www.youtube.com/watch?v=4BEjKUK8DSQ
– Pi Camera project on GitHub: https://github.com/geerlingguy/pi-camera
– Ender 3 V2 (my 3D Printer): https://amzn.to/3ikDRPk
– Twidec 12mm push button (for shutter): https://amzn.to/3ijIj0C
– Waveshare 3.5″ Touchscreen: https://amzn.to/3ZdFley
Raspberry Pi provided the three Camera Modules featured in this video but did not pay for or have any influence over the content of this video.
Support me on Patreon: https://www.patreon.com/geerlingguy
Sponsor me on GitHub: https://github.com/sponsors/geerlingguy
Merch: https://redshirtjeff.com
2nd Channel: https://www.youtube.com/c/GeerlingEngineering
#RaspberryPi #Camera
Contents:
00:00 – A huge upgrade
00:44 – Camera Module 3, four ways
01:53 – An open source camera design
03:03 – Assembly
04:22 – Rigging it up
05:05 – Let’s test it out!
06:51 – Wide Angle and sharpness
08:08 – Autofocus in video
08:41 – You wouldn’t SSH into a GoPro
source
